3-18 Service Manual
7011-2xx
Disable Scanner
This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on
for the new setting’s to take effect. To change the setting, perform the following steps:
1. In the configuration menu, use the arrow keys to scroll to the Disable Scanner menu item.
2. Press .
3. Use the arrow key to scroll to the desired setting. The options are Enable ADF/FB, Disable ADF/FB,
Disable ADF only, Auto Disabled.
4. Press .
5. Press BACK.
6. Scroll to Exit Config Menu.
7. Press . The device restarts.
Font Sharpening
This setting is used to set a text point size value below which the high frequency screens will be used when
printing data. This setting affects only PCL, PostScript and PDF emulators.
setting’s are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high frequency screens.
To adjust the Font Sharpening setting, perform the following steps:
1. In the configuration menu, scroll to the Font Sharpening menu item and press .
2. Use the or to increase or decrease the setting’s value. pressing decreases the value and
pressing increases the value.
3. Press to accept the setting.
Reduced Curl
Note: This only apppears on devices with an instant on fuser.
USB Speed
The USB Speed setting is used to set the throughput of the USB port on the MFP. The setting’s are Auto, which
is the default, and Full. Full forces the USB port to run at full speed.
Exit Config Menu
With the Exit Config menu item displayed, press Select ( ) to exit the Configuration Menu. The printer performs
a power-on reset and returns to normal mode.
To Next Page
Loading...
