Lexmark X203N - Input Tray Tests; Feed Tests; Output bin Tests; Base Sensor Test

Diagnostic aids 3-7
7011-2xx
Input Tray tests
Feed Tests
This test allows you to observe the paper path of media as it passes through the printer. Any installed input tray
can be tested. The pages fed through the printer are blank.
To run the Feed Test:
1. Select INPUT TRAY TESTS from Diag Menu, and press Select ().
2. Select Feed Tests, and press Select ().
3. Select the tray to be tested. Choices are installed trays, including Tray 1,and MP Feeder.
4. Open the upper rear door to view the paper path.
Note: Do not open the upper front door. The test will not run if the front door is open.
5. Select Single or Continuous, and press Select ().
• Single—a single sheet of blank paper is fed, and the test stops.
• Continuous—sheets are fed continuously until Stop ( ) is pressed.
To Exit the test, press Back () or Stop ().
Output bin tests
The Output bin tests setting is used to test the printer’s output bins and its sensors.
Feed Tests
This test verifies that the media from the printer’s default input source feeds to the specific output bin. Press
to select Single, or press and to select Continuous. The Single test feeds one sheet of media to the default
output bin. No buttons are active during this test. The Continuous test feeds media to the default output bin until
is pressed. The indicator light blinks green, and the operator panel displays [Select Output Bin] Feeding...
while either of these tests perform.
Base Sensor Test
These tests allow you to verify the correct functioning of the front door, input, and output sensors.
1. Select Base Sensor Test from Diag Menu, and press Select ().
2. Select the sensor you want to test, and press Select ().
The following test are available: Exit, Front door, and Input.
Printer setup
Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The setting’s affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.
Perm Page Count
You can view, but not change any of the three counts displayed under PAGE COUNTS.