Lexmark X203N - Sending Faxes from Control Panel; Sending Faxes from Computer Software

3-2 Service Manual
7011-2xx
Diagnostics mode
When the Diagnostics mode is entered, each Diagnostics main menu item displays on the operator panel. When
a diagnostic test is selected from the main menu, a sub menu displays and each individual test displays in the
order shown. Any options that are referred to in the menus are displayed when the option is installed.
Available tests
The tests display on the operator panel in the order shown:
Diagnostics mode tests
REGISTRATION
Top Margin These tests are performed to adjust the print head registration. See
“Registration” on page 3-3
Bottom Margin
Left Margin
Right Margin
Quick Test See “Quick test” on page 3-4.
PRINT TESTS
Tray 1 See “Print Tests” on page 3-5.
Manual Feeder (if installed)
Prt Quality Pgs See “Print quality test pages (Prt Quality Pgs)” on page 3-5.
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-5.
Button Test See “Button Test” on page 3-5.
DRAM Test See “DRAM Test” on page 3-6.
INPUT TRAY TESTS
Feed Tests See “Feed Tests” on page 3-7.
OUTPUT BIN TESTS
Feed Tests See “Feed Tests” on page 3-7.
BASE SENSOR TEST See “Base Sensor Test” on page 3-7.
Exit
Front Door
Input
PRINTER SETUP
Defaults See “Defaults” on page 3-7.
Perm Page Count See “Perm Page Count” on page 3-7.
Serial Number See “Serial Number” on page 3-8.
Engine Setting 1 through 4 See “Engine Setting 1-4” on page 3-8.
Model Name See “Model Name” on page 3-8.
Configuration ID See “Configuration ID” on page 3-8.
Edge to Edge See “Edge to Edge” on page 3-9.
Enable Edge to Edge Copy See “Enable Edge to Edge Copy” on page 3-9.
EP SETUP
EP Defaults See “EP Defaults” on page 3-9.
Fuser Temp See “Fuser Temp” on page 3-9.