3-4 Service Manual
7011-2xx
5. Print another copy of the Quick Test to verify your changes.
6. Continue changing the setting’s by repeating steps 3 through 5.
To exit REGISTRATION, press Back (
).
Quick test
The Quick Test contains the following information:
• Print registration setting’s
• Alignment diamonds at the left, right, top. and bottom
• Horizontal lines to check for skew
• General printer information, including current page count, serial number, and code level.
To print the Quick Test page:
Note: Print the Quick Test Page on letter or A4 paper.
1. Select REGISTRATION from DIAGNOSTICS.
2. Use or to select Quick Test, and press .
The message Quick Test Printing… appears on the display.
Once the Quick Test Page completes printing, the Registration screen displays again.
Left margin -50 to +50
Each increment corresponds to 4
pixels at 600 dpi (0.00666 in. or
0.1693 mm).
The default is 0.
A positive change moves the image to the left,
and a negative change moves the image to the
right. No compression or expansion occurs.
Right margin -50 to +50
Each increment corresponds to an
approximate shift of 4 pixels at 600
dpi.
The default is 0.
A positive change moves the image to the left,
and a negative change moves the image to the
right.
Description Value Direction of change
To Next Page
Loading...
