2-20 Service Manual
7011-2xx
Load Manual
<custom type>
Printer does not detect media meeting the description <custom type> in the single
sheet feeder (manual feeder).
The following actions can be taken:
• Load paper, and the job continues.
•press Select ( ), and choose an alternate source for media.
• Cancel the current job.
Load Manual
<custom string>
Printer does not detect media meeting the description <custom string> in the
single sheet feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
•press Select ( ), and choose an alternate source for media.
• Cancel the current job.
Load Manual
<size>
Printer does not detect media meeting the description <size> in the single sheet
feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
•press Select ( ), and choose an alternate source for media.
• Cancel the current job.
Load Manual
<type> <size>
Printer does not detect media meeting the description <type> and <size> in the
single sheet feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
•press Select ( ), and choose an alternate source for media.
• Cancel the current job.
PJL OP Message
PJL Seed Message
PJL ST Message Try one or more of the following:
•press Select ( ) to clear the message, and continue printing.
• Wait for the message to clear.
Remove Paper ADF
This posts when there is paper detected in the ADF upon POR or when the cover
is closed (or any other situation that re-inits the scanner). Message clears when
paper is removed.
Remove Paper
Standard Bin
The standard output bin is full or nearly full. Remove the media from the bin.
30 Invalid Refill Change
Cartridge
Refilled cartridge detected.
31 Defective or Missing
Cartridge
This message is displayed when a defective print cartridge is detected. Replace
the toner cartridge.
32 Unsupported Toner
Cartridge
This message is displayed when an unsupported print cartridge is installed.
Replace the toner cartridge.
34 Short Paper • press Select (
) to clear the message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure paper is properly fitted in the tray.
• Make sure the print job is requesting the correct size of paper.
• Adjust the Paper Size setting for the size paper you are using.
If MP Feeder Size is set to Universal, make sure the paper is large enough for
the formatted data.
• Cancel the current job.
User status and attendance messages (Continued)
User primary message Explanation
To Next Page
Loading...
