41
5.6 Two-Way Record: Recording a call
You may record an ac
tive external/Internal conversation in your Voice
Mail Box. During recording a call, the LED of the Flex Record button
is flashing.
Before using the recording, the following admin have to be checked:
1. Station Data > Station VM Attribute (PGM 127)
1) VSF Aceess: Enable.
2) Two
War Record: ON.
3) Automatic Talk Recording Destination: VSF group No.
4) Automatic Talk Recording Option (OFF/ALL/CO)
- If this option is set to OFF, User can press the
programmed Record button to record.
- If this option is set to ALL, User can record all
conversation without pressing the programmed
Record button.
- If this option is set to CO, User can record the
external call without pressing the programmed
Record button.
2. Station Group Data > Station Group Assignment (PGM
190)
1) The above ‘Automatic Talk Recording Destination’ is
assigned. e.g. 401 as group number
2) Select the group type: VSF-VM
To assign {Two Way Record} Flexible button:
TRANS/PGM + {FLEX} + TRANS/PGM + 80 + HOLD/SAVE
To activate Two-Way Record while on a call:
• Press the programmed Record button, record warning tone is
heard and recording starts.
To stop Two-Way Record while on a call:
• Press the programmed Record Soft button or,
• Hang-up, return to idle.
To play Two-Way Record:
• Press the CALL BACK button,
• Select the VSF MSG to use Volume button or Navigation key
• Enter the station number and Password.
• User can check the recoding.
To Next Page
Loading...
Need help?
General
