Operation - Mass Concentration Mode
5HY 5-41
• Instr - Indicates the state of the instrument at the time the data was
recorded. Instrument states include GOOD or SRVC.
If SRVC appears, printouts will say “Service Required” and the
sensor may need cleaning. Please contact Lighthouse Technical
Support at 1-(800) 945-5905 or techsupport@golighthouse.com.
• Flow - Indicates the flow state of the instrument at the time the data
record was recorded. Flow is recorded as OK or ALRM. If the flow
was in alarm, it will print as Flow: Alert on the printouts.
• Alarm - Indicates (NONE or YES) if the data record exceeded any
of the alarm thresholds of any of the channels that were enabled for
alarms. If the data record exceeded alarm thresholds, printouts
show “Alarm: Yes”.
• Laser - Indicates the status of the laser at the time the data record
was recorded; possible laser states include OK or SRVC. If the laser
needs to be serviced, it will print as Laser: Service.
If laser state is SRVC, please contact Lighthouse Technical Support
at 1-(800) 945-5905 or techsupport@golighthouse.com.
Analog Data
If the Temperature/Relative Humidity probe is attached during data
recording, the analog data will be listed in the Data screen.
PRINT RECORD
Note: PARTICLE data
may be printed, even if the
data was taken in MASS
mode. On the MAIN
Screen, press the MASS
button, which changes it to
PARTICLE. Return to this
point to print the particle
counts.
When you push the PRINT RECORD button, whatever record is
currently displayed in the Data screen will print as a single sample
record. The record will print according to the settings in the Print
Configuration.
The form in which the data is printed (PM or ugr/m3) is dependent the
Particle Display setting in CFG:Settings. The left side of Figure 5-49 is
a PM printout, the right side is a ugr/m3 printout.
To Next Page
Loading...
