Operation - Particle Mode
5HY 4-11
CONFIGURATION
Screen
Press CONFIG on the MAIN screen to display this screen as shown in
Figure .
Figure 4-10 Configuration Screen
Data Setup includes buttons to change temperature units for analog
channels, set sample record parameters, sample settings, enable/disable
alarms and thresholds and clear the data buffer.
Device Setup includes buttons to configure the instrument’s date and
time, set the LCD contrast, adjust the instrument’s beep volume, enable
the instrument to AutoStart, set the instrument’s communication
address, setting print options, enable password restrictions, and/or
(with proper authorization) adjust service settings.
DATA SETUP
Figure 4-11 Data Setup options
To Next Page
Loading...
