Operation - Particle Mode
5HY 4-45
• Laser - Indicates the status of the laser at the time the data record
was recorded; possible laser states include OK or SRVC. If the laser
needs to be serviced, it will print as Laser: Service.
If laser state is SRVC, please contact Lighthouse Technical Support
at 1-(800) 945-5905 or techsupport@golighthouse.com.
ANALOG DATA
If the Temperature/Relative Humidity probe is attached during data
recording, the analog data will be listed in the Data screen.
Note: Mass
Concentration data may be
printed, even if the
instrument was in Particle
mode when the sample
was taken. On the MAIN
Screen, press the
PARTICLE button, which
changes to MASS. Then
return to this command to
print the Mass
Concentration data.
PRINT RECORD
When you push the PRINT RECORD button, whatever record is
currently displayed in the Data screen will print as a single sample
record. The record will print according to the settings in the Print
Configuration. See Figure 4-54.
Figure 4-54 Examples of Output from Auto Printout of Sample
**HANDHELD**
Serial #: 30804001
-----------------------
Location: 29
08-02-03, 15:34:46
Sample Time: 00:01:00
Flow: 0.1 cfm
Laser: OK
74.7 DegF 52.2 %RH
Particle Counts:
Size Diff Cumul
0.3 29118 32543
0.5 2572 3425
0.7 797 853
1.0 29 56
2.0 24 27
5.0 33
**HANDHELD**
Serial #: 30804001
-----------------------
Location: 29
08-02-03, 15:34:46
Sample Time: 00:01:00
Flow: 0.1 cfm
Laser: OK
74.7 DegF 52.2 %RH
Particles/ Ft^3:
Size Diff Cumul
0.3 2222.0 2350.0
0.5 115.0 128.0
0.7 13.0 13.0
1.0 0.0 0.0
2.0 0.0 0.0
5.0 0.0 0.0
This indicates
whether the data
viewed is in RAW
counts or
Normalized counts.
To Next Page
Loading...
