Lighthouse HANDHELD 3016 IAQ Gen E Operating Manual
3-6 5HY
Connect Power
Connect the power adapter as illustrated in the following steps:
1. Insert the round DC power plug into its receptacle on the left side
of the HANDHELD. See Figure 3-7.
Figure 3-7 DC power plug
2. Push the connector in until fully seated as shown in Figure 3-8.
Figure 3-8 Inserting DC power plug.
3. Plug the adapter’s AC power cord into the AC power source. The
battery will begin and continue to charge until it is fully charged
or DC power is removed.
To Next Page
Loading...
