Lighthouse HANDHELD 3016 IAQ Gen E Operating Manual
4-8 5HY
LOCATION Selection
Changing Locations
The location number for the environment to be measured can be
changed by pressing the LOCATION button at the top of the MAIN
screen. The following screen will display. See Figure 4-7.
Figure 4-7 Location Select Screen
• The blue highlight indicates which location is currently selected.
• Use the UP and DOWN arrows to select a location. The single
arrows will move the cursor up and down by a single line.
Locations can also be selected by touching the location name on the
screen.
• The AUTO INC button, when activated will allow the user to
advance to the next location once the current cycle is completed.
• Press the MAIN button to return to the MAIN screen. Whichever
location is currently selected will be the location displayed on the
MAIN screen.
Locations in AUTO Mode
When the instrument is in Automatic Mode and the START button is
pressed, the instrument will start counting particles automatically
according to the SAMPLE time, HOLD time and number of cycles that
are configured.
To Next Page
Loading...
