Operation - Particle Mode
5HY 4-21
Note: Alarms are
triggered per sample
record. At the end of the
sample time, the alarms
reset.
Press BACK to return to the Configuration screen or press MAIN to
return to the MAIN screen.
Figure 4-21 MAIN screen with 2 channels enabled for alarming
Note: To receive alarms,
the Sample Time must be
greater than 1 second.
When a particle channel that is enabled for alarming goes into alarm,
the selection cursor (>) and the channel size is highlighted in red. See
Figure 4-22.
Figure 4-22 Channel in Alarm
To Next Page
Loading...
