MMX2 series – User's Manual 72
Setting Output Signal Type
ɯ <ip><out>
ɯ body: <signal_type>
ɯ <ip><out>
ɯ body:
Audio Port Settings
Switching Audio Input
ɯ <ip>
ɯ body: <audio_in>:O3·
ɯ <ip>
ɯ <ip><audio_in>
Setting Autoselect Operation Mode
ɯ <ip>
ɯ body: <op_mode>
ɯ <ip>
ɯ body: <out>
ɯ <ip><audio_port>
ɯ body: <locked_state>
Muting the Audio Port 1
ɯ <ip><audio_port>
ɯ body: <muted_state>
Muting the Audio Port 2
ɯ <ip>
ɯ body: <muted_state>
ɯ <ip><audio_port>
ɯ <ip>
ɯ body: <level>
ɯ <ip>
ɯ body: <percent>
Setting the Balance
ɯ <ip>
ɯ body: <level>
ɯ <ip>
ɯ body: <step>
ɯ <ip>
ɯ body: <step>
Analog Audio Output Balance Setting by Steps
ɯ <ip>
ɯ body: <step>
EDID Management
ɯ <ip>
ɯ <ip>
ɯ <ip><user_edid>
Emulating an EDID to an Input Port
ɯ <ip>
ɯ body: <source>:<destination>
Emulating an EDID to All Input Ports
ɯ <ip>
ɯ body: <source>
Copying an EDID to User Memory
ɯ <ip>
ɯ body: <source>:<destination>
To Next Page
Loading...
Need help?
General
