Lightware UCX Series - Ethernet Interface

5. Device Concept UCX series – User's Manual 34

Ethernet Interface
Summary of Ethernet ports
USB-C Ethernet
8 1
UCX-4x2-HC30 2x 3x
Ethernet Port Diagram
The device can be controlled via Ethernet (standard RJ45 connector). This interface supports:
▪              
section.
▪             
protocol in the section.
▪ 
▪ 
USB-C in
USB-C in
CPU
Ethernet
Ethernet
Ethernet
USB-Ethernet
bridge
USB-Ethernet
bridge
Ethernet
Layer
10/100
10/100
10/100
10/100
10/100
10/100
USB-Ethernet Bridge
The built-in USB-Ethernet bridge provides Ethernet for the USB-C connection. It is still available while the USB
3.1 Gen1 data channels are reserved for video or USB data transmission as it uses the USB-2.0 layer.
System Requirements of USB-Ethernet Bridge
The built-in USB-Ethernet bridge operates as a third-party USB Ethernet hub.
▪ 
▪ 

ATTENTION!  Enabling the third-party device operation is necessary (System Preferences -> Security &
Privacy -> General -> Allow software driver from "Microchip").
▪ 




