Lightware UCX Series - Handling Upgrade Failures

8. Firmware Upgrade UCX series – User's Manual 88


Done
successfully and a message appears; you can close the software.


down and restarting the device is recommended.
If the Upgrade is not successful
▪ Restart the process and try the upgrade again.
▪ 
written in the User's manual of the device. Please note that backup and restore cannot be performed
in this case.
▪ If the backup cannot be created for some reason, you will get a message to continue the process
without backup or stop the upgrade. A root cause can be that the desired device is already in bootload

▪ If an upgrade is not successful, the Export log button becomes red. If you press the button, you can

 #bootload



