8. Firmware Upgrade UCX series – User's Manual 85
ATTENTION!
transmitter is switched to bootload mode. Signal processing is not performed. Do not interrupt the
Introduction
DIFFERENCE:
Preparation
can be upgraded usually over one dedicated interface, which is the Ethernet in most cases.
▪ LFP2 le,
▪ LDU2 software installed on your PC or Mac.
Both can be downloaded from .
Optionally, you can download the release notes
About the Firmware Package (LFP2 File)
the upgrade on your device.
▪
▪
▪
LDU2 Installation
ATTENTION! Minimum system requirement: 2 GB RAM.
INFO:
Download the software from .
Installation in case of Windows OS
Run the installer. If the User Account Control displays a pop-up message click Yes.
Installation Modes
Normal install Snapshot install
and macOS
The installer can update
only this instance
Cannot be updated
One updateable instance
may exist for all users
Many different versions can be
installed for all users
ATTENTION! Using the default Normal install is highly recommended.
INFO: If you have a previously installed version you will be prompted to remove the old version before
installing the new one.
Installation in case of macOS X
the desired folder.
INFO: This type of installer is equal with the Normal install
To Next Page
Loading...
Need help?
General
