Lightware UCX Series - OCS Port Configuration; Querying the Input Level of an OCS Pin; Set the Sensor Type; Querying the Reported OCS State

 UCX series – User's Manual 80


DIFFERENCE:  

Command and Response #ocs #new
ç 
æ <value>
Parameters
Parameter Parameter description  
<value> The input value of the OCS pin.
High
high level
Low
low level
Example
ç 
æ 
Set the Sensor Type
Command and Response
ç <sensor_type>
æ <sensor_type>
Parameters
Parameter Parameter description  
<sensor_type> 
input level means the occupancy.
Active low
Occupancy status is
'Occupied' when the
input level is low.
Active high
Occupancy status is
'Occupied' when the
input level is high
(default value).
Example
ç 
æ 

Command and Response
ç 
æ <status>
Parameters
Parameter Parameter description  
<status> It reports the occupancy
state of the room depending
on the sensor type.
Free


when SensorType=Active low and Inputlevel=High
Occupied

Inputlevel=High or

Example
ç 
æ 



