What does “HALL POWER SHORT” mean on my Lippert Components Automobile Accessories touch panel?
The “HALL POWER SHORT” message on your Lippert Components Automobile Accessories touch panel indicates a short circuit has been detected on one or more of the jack hall effect power lines. You should check the harness and replace or repair it.
Why does my Lippert Components Automobile Accessories touch panel say “FEATURE DISABLED”?
The “FEATURE DISABLED” message on your Lippert Components Automobile Accessories touch panel can appear for a couple of reasons: * If hitch recognition was requested but no hitch height has been set, perform an AUTO LEVEL sequence to establish the hitch height. * Alternatively, the zero point may not be set, in which case you should set the zero point.
What does it mean if my Lippert Components Automobile Accessories touch panel says “CAN’T COMPLETE LEVEL IN THIS LOCATION. PLEASE RELOCATE RV TO FLATTER TERRAIN”?
This message on your Lippert Components Automobile Accessories touch panel indicates that the trailer is parked on a steep incline during auto level. The front cannot be leveled because the front jacks are already fully retracted. You will need to relocate the trailer to flatter terrain.
What does “OUT OF STROKE” mean on my Lippert Components Automobile Accessories touch panel?
The “OUT OF STROKE” message on your Lippert Components Automobile Accessories touch panel means that the trailer is not level. This can happen if the sensor is unsecured, so check and secure the sensor placement. It can also occur if you're on an uneven or sloped site, in which case you should relocate the trailer.
Why does my Lippert Components Automobile Accessories touch panel show “EXCESS ANGLE”?
The “EXCESS ANGLE” message on your Lippert Components Automobile Accessories touch panel suggests that your trailer is not level. This can happen if the sensor is unsecured, so check and secure the sensor placement. It can also occur if you're on an uneven or sloped site, in which case you should relocate the trailer.
What to do if my Lippert Components Automobile Accessories touch panel displays “AUTO LEVEL FAILURE”?
The “AUTO LEVEL FAILURE” message on your Lippert Components Automobile Accessories touch panel can be triggered by a couple of things. First, check that the sensor is securely placed. If the sensor is secure, test the battery voltage under load, and charge or replace the battery if necessary, as a voltage drop can also cause this error.
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
Detailed instructions for mounting the system's brackets and jacks.
Guides the installation of front spacer kits and C-jacks onto the trailer frame.
Guides the installation of rear mounting brackets and 5K short jacks.
Procedure for installing the primary power tongue jack.
Instructions for locating and mounting the leveling sensors for optimal performance.
Steps for installing the main system controller.
Detailed steps for the automatic leveling sequence of the trailer.
Guides to interpreting LED status and handling system error displays.
Troubleshooting specific error messages shown on the OneControl touch panel.
Steps to clear special jack error codes by homing the jacks.
Procedure to set the system's zero point for accurate auto leveling.
Schematic illustrating the electrical connections of the leveling system components.
General| Brand | Lippert Components |
|---|---|
| Model | ground control TT |
| Category | Lifting Systems |
| Language | English |
To Next Page
