Page 20 / 43
4.2.4 Manual reset
When the actual desktop position no longer corresponds to the height displayed or
you wish to use a configured control unit on another identical electric height-
adjustable desk, you have to reset the lowest desktop position to the minimum
height.
1.
Press the desktop down key.
Keep pressing it until the desktop has reached the lowest position
(programmed desktop position).
2.
Press the desktop down key again and keep pressing it.
After about 5 seconds, the desktop will slowly move further down
until it reaches the absolutely lowest desktop position possible.
3.
Release the desktop down key. The electric height-adjustable
desk can now be used again normally.
Note: this function is available for both motorgroups separately. Please
read the manual of the used handswitch to see which buttons are linked
to which motor group!
Danger: intelligent system protection (ISP) is not enabled during all
resets and limit position calibration. Please note that there is a potential
risk of pinching in this case.
To Next Page
Loading...
Need help?
General
