Page 35 / 43
6.3 Error indication with LEDs
Depending on the version, the COMPACT is equipped with LEDs to indicate errors
even if a handswitch without display is used. These LEDs are placed on the housing
top over the handswitch socket and each motor socket.
Figure 7: LEDs on COMPACT
If a LED is permanently on or blinking, please check the following table for error
descriptions and remedies.
Error Code:
Control box LED is blinking
Description:
Internal Error
Remedy:
Make a manual reset.
Unplug power cord and plug it in again
after a few seconds.
Unplug power cord and contact the
customer service.
To Next Page
Loading...
