LOGICDATA SMARTneo-3G User Manual

SMARTNEO OPERATING MANUAL // PAGE 20
1. Press and hold the DOWN Key until the table stops at the lower position limit
2. Release the DOWN Key
3. Press and hold the DOWN Key again
▸ The table will move down slightly, then up again
4. Release the DOWN Key
▸ The Position Reset Procedure is complete.
INFO If your SMARTneo-2G / SMARTneo-3G has been parameterized with additional stopp-
ing points (e.g. a Container Stop Position), repeat Step 3 until the table has moved
upwards again.
6.8 CONFIGURATION EXAMPLE
1 SMARTneo-2G / SMARTneo-3G Control Box
2 Actuators
3 User interface (see Chapter 6.3)
4 Mains cable
1
3
4
2 2
M1
AC
M2
HC
Fig. 6: Conguration Example SMARTneo-2G / SMARTneo-3G

LOGICDATA SMARTneo-3G Specifications

General

Brand	LOGICDATA
Model	SMARTneo-3G
Category	Control Unit
Language	English