SMARTNEO OPERATING MANUAL // PAGE 24
WARNING Risk of minor or moderate injury through unauthorized modications
The control system rmware is supplied in Europe with the double-click function
disabled. After enabling this functionality the safety of the end product must
be evaluated.
• A risk assessment to demonstrate conformity to the requirements of Machinery
Directive 2006/42/EC is required prior to use.
• LOGICDATA is not liable for injuries or damage caused by activating the
double-click function.
1. Double-click the UP or DOWN Key to move the table in the direction of the
position you wish to reach (upwards for “Stand”, downwards for “Sit”.
▸ The table will move to the Memory Position. You do not have to hold the Key.
Press any Key during Auto-Movement to stop the table from moving.
7.3.2 USING A COMFORT HAND CONTROL
Version A (without double-click function):
2
1. Press and hold the required Memory Position Key (e.g. 2).
2. The Table Top will move until the saved Table Top height has been reached. If you
release the Key before the Memory Position is reached, the table will stop
2
▸ Release the Memory Position Key
7
3
▸ The display shows the Table Top height (e.g. 73 cm)
Version B (Auto-Movement with double-click function):
INFO The double-click function is available only for SMARTneo-2G / SMARTneo-3G Control
Boxes sold in US markets. It is an option congured by LOGICDATA only on request.
INFO If you press any Key while the table moves to a Memory Position, the Table Top will
stop moving immediately. To continue, you must select the Memory Position again.
To Next Page
Loading...
Need help?
General
