SMARTNEO OPERATING MANUAL // PAGE 5
1 GENERAL INFORMATION
Documentation for the SMARTneo-2G / SMARTneo-3G consists of this Operating Manual and several other
documents (Other applicable documents, page 5). Read all documentation before assembling or operating
the table system. Keep all documentation for as long as the product is in your possession. Ensure that all
documentation is provided to subsequent owners. Go to www.logicdata.net for more information and sup-
port. This Manual may change without notice. The most recent version is available on our website.
1.1 OTHER APPLICABLE DOCUMENTS
This Operating Manual assumes that the reader has read the following documents
• Datasheet and Operating Manual for the installed Actuator(s)
• Datasheet and Operating Manual for the installed User Interface (Hand Control or other)
• Datasheet and Operating Manual (if applicable) for any installed accessory products
• SMARTneo-2G Cascading Manual (applies also to SMARTneo-3G), if a Cascading System is to
be installed
1.2 COPYRIGHT
© December 2023 by LOGICDATA Electronic und Software Entwicklungs GmbH. All rights reserved, except
for those listed in Chapter 1.3 Royalty-free use of images and text on page 5.
1.3 ROYALTY-FREE USE OF IMAGES AND TEXT
After purchase and full payment of the product, all text and images in Chapter 2 “Safety”, may be used free
of charge by the customer for 10 years after delivery. They should be used to prepare end user documen-
tation for Height-Adjustable Table Systems. The license does not include logos, designs, and page layout
elements belonging to LOGICDATA. The Reseller may make any necessary changes to the text and images
to adapt them for the purpose of end user documentation. Texts and images may not be sold in their current
state and may not be published or sublicensed digitally. The transfer of this license to third parties without
permission from LOGICDATA is excluded. Full ownership and copyright of the text and graphics remain
with LOGICDATA. Texts and graphics are oered in their current state without warranty or promise of any
kind. Contact LOGICDATA to obtain text or images in an editable format (documentation@logicdata.net).
1.4 TRADEMARKS
Documentation may include the representation of registered trademarks of goods or services, as well as
information about copyright or other proprietary expertise of LOGICDATA or third parties. In all cases, all
rights remain exclusively with the respective copyright holder. LOGICDATA® is a registered trademark of
LOGICDATA Electronic & Software GmbH in the USA, the European Union, and other countries.
To Next Page
Loading...
Need help?
General
