LOGICDATA SMARTneo-3G User Manual

SMARTNEO OPERATING MANUAL // PAGE 28
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
2. Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is deleted (Container Stop if you are
in the bottom half of the movement area, Shelf Stop if you are in the top half).
8.4.2 USING A COMFORT HAND CONTROL
To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click twice.
▸ The Container Stop / Shelf Stop Position is saved.
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click once.
▸ The Container Stop / Shelf Stop Position is deleted.
8.5 CORRECTING THE HEIGHT DISPLAY
This feature changes the height displayed on the Hand Control. It does not aect the table‘s actual height.
1. Press the SAVE Key.
S
-
▸ The display shows S –.
2. Press and hold the DOWN Key for approximately 5 seconds.
▸ The display starts to ash.
▸ Use the UP Key or DOWN Key to set the new height.

LOGICDATA SMARTneo-3G Specifications

General

Brand	LOGICDATA
Model	SMARTneo-3G
Category	Control Unit
Language	English