LOGICDATA SMARTneo-3G User Manual

SMARTNEO OPERATING MANUAL // PAGE 4
7 Operation 21
7.1 Adjusting the Table Top Height 22
7.2 Saving a Memory Position 22
7.2.1 Using a Basic Hand Control 22
7.2.2 Using a Comfort Hand Control 23
7.3 Adjusting the Table to a Memory Position 23
7.3.1 Using a Basic Hand Control 23
7.3.2 Using a Comfort Hand Control 24
8 Software-Dependent Functions 25
8.1 Low Speed Area 25
8.2 Safety Area 26
8.3 Factory Reset (S0 Reset) 26
8.3.1 Using a Basic Hand Control 26
8.3.2 Using a Comfort Hand Control 27
8.4 Container Stop and Shelf Stop Positions 27
8.4.1 Using a Basic Hand Control 27
8.4.2 Using a Comfort Hand Control 28
8.5 Correcting the Height Display 28
8.6 Changing the Displayed Unit of Measurement 29
(cm / inch)
8.7 Duty Cycle Monitoring 29
9 Actuator Setup 30
9.1 Plug Detection 30
9.2 Slimdrive Detection: Changing to a Dierent 30
Slimdrive Type
9.3 Auto-Detect: Changing the Number of Slimdrives 31
9.4 Changing the Number of Actuators (Other) 31
10 Troubleshooting 33
10.1 Possible Problems and Their Solutions 33
10.2 Click Codes 34
10.3 Error Messages on the Display 34
11 Additional Information 37
11.1 Disassembly 37
11.2 Collision Detection 37
11.2.1 Intelligent System Protection 37
11.2.2 Drive Back Function 37
11.2.3 Disabling Sensor Detection (S3 Menu) 38
11.3 Maintenance 39
11.4 Disposal 39

LOGICDATA SMARTneo-3G Specifications

General

Brand	LOGICDATA
Model	SMARTneo-3G
Category	Control Unit
Language	English