24
Different types of side cutter heads
PH 260 comes with cutter heads for replacable moulding knives.
There are also other types of cutter heads, for example solid
cutter heads. See Logosol’s Moulding Knives Catalogue.
Different types of planing knives
PH 260 comes with solid HSS
planing knives. There are also
other types of planing knives, for
example TCT knives. See Logosol’s
Moulding Knives Catalogue.
Line laser
Logosol can supply a line laser that facilitate the lining up of the
workpiece before it is fed through the machine. The machine
must then be xed to the oor. The laser can be tted to the
ceiling in the room. Laser technology is developing rapidly. Due
to this, the design of the line laser can vary. Contact Logosol to
get information about current price and design.
Additional spacers for height adjusting the side cutters
No matter how many you have, it can always be good to have
some more. For instance, you can save the set used for a special
moulding: If you have produced a moulding on the left and the
right side of a board, e.g. tongue and groove, you can keep the
spacers together with the knives used for that moulding. When
you are going to make the same moulding again, the setting
of the cutters height is already calculated. It is a smart way to
save time! Spacers for setting the height of the side cutters: 2X5
spacers of the sizes 0,1; 0,2; 0,5; 1,0 and 2,0.
Ref. no. 7502-001-0230
Tormek grinder
For grinding planing and moulding knives and other tools. 220
V. It comes with a 147 page hardback with good instructions.
As accessories there are two jigs, one for planing knives and
one for moulding knives. The jig for moulding knives, invented
by Mattias Byström, Logosol, works like this: A frame that is
vertically adjustable, is placed over the grindstone. The moulding
knife is tted in a magnetic holder, which is moved on the frame
over the grindstone until the entire moulding knife is ground on
its underside and it has a new cutting edge with unchanged
prole.
Tormek grinder: Art.nr.
7010-000-1000
Jig for planing knives: Ref.
no. 7010-000-1005
Jig for moulding knives: Ref.
no. 7010-001-1012
Machine cleaner
Unbeatable product for
cleaning wood processing
machines. Particularly
aggressive to resin.
Ref. no. 7500-001-5000
Low friction agent
Apply the low friction agent to
the machine table and the feed tables to enhance the feeding
through the machine. The low friction agent also prevents resin
and chips from sticking to the table.
Ref. no. 7500-001-5050
Moisture meter
Measure the moisture level in your timber
before planing it. Logosol is constantly looking
for the product that offers the most for the
money. Due to this, the design and price can
vary.
Ref. no. 9999-000-0012
To Next Page
Loading...
