6
Tools Needed
30 mm spanner (supplied)
10 mm spanner (supplied)
4 mm Allen key (supplied)
6 mm Allen key (supplied)
13 mm ring spanner
10 mm ring spanner
Adjustable spanner
Vernier calliper
Ruler 30-50 cm (12-20”)
TIP! Make a tool board
for the tools you use, and
place it near the planer
so that you can easily
reach it. Look at the tool
board before starting
the machine in order to
make sure that no tool is
missing. Perhaps there
is a tool left inside the
machine!
Feed table bolts and
washers (4)
Side cutter spacers (19)
Spanners (2)
30 & 10 mm
Upper cutter
setting block (1)
Feed table mounting plates (2)
Side cutter crank (1)
Table adjustment
crank (1)
Control panel
mounting bolts and
washers (2)
Accessory:
Spindle adapter,
30 mm to 1-1/4’’
Coach screws, feed
table (4)
Allen keys (2)
To Next Page
Loading...
