23
Accessories
Logosol has a wide range of accessories for PH 260. The
accessories are also presented in Logosol’s Moulding Knives
Catalogue and Product Catalogue.
In- and out-feed tables
Made of sheet steel. They fol-
low the machine table when
it is raised or lowered. See
the section In- and out-feed
tables.
Ref. no. 7500-000-1000
Castor set
Four turnable and lockable double
castors. Diameter 75 mm.
Ref. no. 7500-000-1025
Chip extractor
We strongly recommend that Logosol’s
3 kW chip extractor with an air ow rate
of 4000 m3/h is used. This chip extrac-
tor is well tried and has proven to be
very reliable. You can count on getting
chip handling problems if using a chip
extractor that is too small.
Ref. no. 7000-000-2030
Metre counter
It is good to know when you have
machined enough boards for
your project, or what amount you
should charge your customers.
The metre counter is screwed
to the frame on the back side of
the machine. With its mechanical
counter it continuously shows the
number of machined metres starting from the latest resetting.
Due to a quick coupling, the metre counter can easily be
mounted and dismounted.
Ref. no. 7500-000-1040
Setting rule
The setting rule signicantly facilitates the adjustment of the side
fences, and it saves time when you have mounted new moulding
knives in the machine. You can read about how to use the setting
rule in the section Adjusting the fences at cutter 2.
Ref. no. 7502-001-0405
Magnetic adjuster
Well-tried equipment for quick and
accurate adjustment of planing
knives in the upper and lower cutter.
The magnetic adjuster comes in
a nice wooden box together with
detailed instructions.
For the lower cutter: Ref. no. 7500-001-0051
For the upper cutter: Ref. no. 7500-001-0050
Micro adjustment
Facilitates the adjustment of the
side fences. When using the micro
adjustment, you rst make a rough
adjustment by moving the axle
in its holder. After this, you ne-
tune the position of the fence by
turning the knob on the back of
the micro adjustment. When doing
this, the clamping plate holding the
micro adjustment should be lightly
tightened. When the ne-tuning is
done, the clamping plate is rmly tightened so that the micro
adjustment is xed.
Ref. no. 7502-001-0098
Stepless feeder (4-24 m/min.)
PH 260 comes with a stepless feeder with a
speed of 2-12 m/min. When planing boards
to size, for instance, it can be of advantage
to increase the feeding speed. To make
it possible to feed up to 24 m/min. more
power is required. So, to obtain this speed
both the motor and the planetary gear have
to be replaced. The assembly is simple.
Ref. no. 7000-000-2001
Jointer fence
With an extra-long fence in front
of the stationary side cutter, your
machine becomes a jointer. For
jointing workpieces that are up to 90
cm (35”) long.
Ref. no. 7502-001-0102
To Next Page
Loading...
