Loop Telecom Loop-V 4200 - 4 Front Panel Operation; Figure 4- 1 Loop-V 4200 Series Front Panel; Figure 4- 2 Menu Tree

Chapter 4 Front Panel Operation
4-1
4. FRONT PANEL OPERATION
The front panel operation utilizes a two by forty (2 x 40) character LCD display window and four keypads
each labeled with ESC, ENTER, left arrow '<', and right arrow '>', as shown in Figure 4-1.
ENTER key is used to move down the menu tree or to enable a selection.
LEFT and RIGHT arrow keys show other menu item in the same level.
ESC key returns the operation to an upper layer menu up to the main menu.
NOTE: The ENTER key must be used to confirm a change. Where YES is shown at the lower right corner, it
must be selected to enable a change.
Figure 4- 1 Loop-V 4200 series Front Panel
Each display only shows one menu item. The main menu is shown in Figure 4-2. It is the first menu
displayed after power up.
Figure 4- 2 Menu Tree
Main
Menu
PORT
Controller
ALARM MISC
STATUS
LOCK
MSG_
CODE
RESET
QUEUE
SETUP
CLEAR
TSI-MAP
DATE
INFO
S/ W
H/ W
SERIAL
MCLK
CURR
CON-
SOLE
BAUD
DATA
STOP
PARITY
XONOFF
IP
STORE
INTERF
MY-IP
SUBNET
STATUS
RECOVER
SECOND
MASTER
TRAP-IP
GATEWAY
CONSOLE
9600, n.8.1
IN OUT MON
K
A
BCDEFHJ
TEST
POWER
ACO
ENTER
ESC
Loop-V
MUXMASTER