Loop Telecom Loop-V 4200 - Atm;T1 Port; Atm;E1 Port; Inband Management

Chapter 4 Front Panel Operation
4-8
4.2.4.7 ATM/T1 PORT
From the Configuration menu, use the arrow keys to select the TSI-Map menu.
Then use the arrow keys to select the T1 ATM/FR card, in this case, port E.
TSIMAP>Select Port:<ATM/FR>
A B C D E F H J K Z
After pressing ENTER from the above LCD, the following LCD will be displayed.
MAP>[iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii]
E_01(ATMT,d,NOCAS)<->IDLE
4.2.4.8 ATM/E1 PORT
From the Configuration menu, use the arrow keys to select the TSI-Map menu.
Then use the arrow keys to select the E1 ATM/FR card, in this case, port F.
TSIMAP>Select Port:<ATM/FR>
A B C D E F H J K Z
After pressing ENTER from the above LCD, the following LCD will be displayed.
MAP>[iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii]
F_01(ATME,d,NOCAS)<->IDLE
4.2.4.9 Inband Management
From the Configuration menu, use the arrow keys to select the TSI-Map menu.
Then use the arrow keys to select the inband management, port Z.
TSIMAP>Select Port:<INBAND>
A B C D E F H J K Z
Inband management stream, port Z, only supports DS0 (64K) mapping.
MAP>[diiiiiiiiiiiiiiiiiiiiiiiiiiiiii]
Z_01(INBN,d,NULL)<->H_01(FE1,d,NOCAS)