Loop Telecom Loop-V 4200 - Tsi-Map; Dte Port; E1 Port; T1 Port

Chapter 4 Front Panel Operation
4-6
4.2.4 TSI-MAP
The TSI-Map menu is used to monitor the port assignment for each DS0 time slot.
CONTROLLER>IP DATE INFO TSI-MAP MCLK
TSI-MAP>A B C D E F H J K Z
First, the port must be selected.
4.2.4.1 DTE PORT
From the Configuration menu, use the arrow keys to select TSI-Map menu.
Then use the arrow keys to select the DTE device, in this case port A.
TSIMAP>Select Port:<DTE>
A B C D E F H J K Z
After pressing ENTER from the above LCD, the following LCD will be displayed.
NOTE:
TSI-MAP setting for DTE port must be set up from the first time slot. Then do the following time slots
in sequence. Users are not allowed to set up the TSI-MAP for the DTE port by random settings.
MAP>[iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii]
A_01(DTE,d,NULL)<->IDLE
4.2.4.2 E1 PORT
From the Configuration menu, use the arrow keys to select the TSI-Map menu.
Then use the arrow keys to select the E1 card, in this case port B.
TSIMAP>Select Port:<FE1>
A B C D E F H J K Z
After pressing ENTER from the above LCD, the following LCD will be displayed.
MAP>[iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii]
B_01(FE1,d,NOCAS)<->IDLE
4.2.4.3 T1 PORT
From the Configuration menu, use the arrow keys to select the TSI-Map menu.
Then use the arrow keys to select the T1 card, in this case port C.
TSIMAP>Select Port:<FT1>
A B C D E F H J K Z
After pressing ENTER from the above LCD, the following LCD will be displayed.
MAP>[iiiiiiiiiiiiiiiiiiiiiiii]
C_01(FT1,d,NOCAS)<->IDLE