Chapter 5 Terminal Operation
5-11
5.9 Configuration Download/ Upload
After configuration downloads, the configuration for each plug-in card would be as follows. If any plug-in card
in any position is different type, factory default configuration is automatically downloaded to the new card. If
any plug-in card in any position is the same type, depending on card type, then the following happens:
y For E1, T1, and DTE plug-in cards, the previous configuration is automatically downloaded.
y For Router plug-in card, the factory default configuration is assigned to the new card.
y For E1/ T1 ATM Frame Relay plug-in card, (a) The port configuration for E1 or T1 is automatically
downloaded, (b) The Frame Relay management setup is factory default configuration.
Under the "Controller Menu", press "T" to enter in the "Download/ Upload SysConfig" screen. Then move the
cursor to select DOWNLOAD to setup system configuration. The current selection will be highlighted by an
asterisk (*).
5.9.1 Download Configuration
LOOP V4200-9 ===Download/Upload SysConfig=== 17:34:36 04/19/2001
>> Select ? *DOWNLOAD UPLOAD
Press ENTER from the above screen. The following screen will show.
LOOP V4200-9 === Download SysConfig === 15:52:06 10/25/2001
ARROW KEYS: CURSOR MOVE, BACKSPACE to edit, ESC to abort
TFTP Server IP : 140.132.001.136
SysConfig File Name : 09.CFG__________________________________________________
<< Press ESC key to abort, ENTER key to continue >>
LOOP V4200-9 === Download SysConfig === 15:54:20 10/25/2001
ARROW KEYS: CURSOR MOVE, BACKSPACE to edit, ESC to abort
TFTP Server IP : 140.132.001.136
SysConfig File Name : 09.CFG
15:53:42 10/25/01 Downloading SysConfig...Recieved 384 Blocks
15:54:05 10/25/01 check sum ok
15:54:05 10/25/01 Validation ok
15:54:06 10/25/01 Waiting...
15:54:20 10/25/01 Download Success
15:54:20 10/25/01 Received 196608 bytes in 39 seconds
<< Press ESC key to abort, ENTER key to continue >>
To Next Page
Loading...