Chapter 4 Front Panel Operation
4-13
4.5.2 MSG Code
The MSG-code menu shows error codes and error descriptions. Table 3-7 lists error codes and messages.
MISC>LOCK MSG_CODE RESET CONSOLE STORE
MESSAGE>NEXT PREV
ERROR>NEXT PREV 1
MSG01: A loopback is in effect
4.5.3 RESET
Select RESET to simulate a power up sequence including a self test of the controller as when power is first
turned on. A password is required to effect this operation.
MISC>LOCK ERROR_CODE RESET CONSOLE STORE
RESET>Reset Controller
4.5.4 Console Port
These menus are used to configure the console port for data rate, data bits, stop bits, parity bit, XON-XOFF
control, interface type, and SNMP control.
MISC>LOCK ERROR_CODE RESET CONSOLE STORE
CONSOLE>BAUD DATA STOP PARITY XONOFF
4.5.4.1 BAUD Rate
Press ENTER from Console Port Baud Rate menu. To change data speed, use the arrow keys to cycle
through to a desired selection and press ENTER.
CONSOLE>BAUD DATA STOP PARITY XONOFF
38400 19200 *9600 4800 2400 1200
4.5.4.2 Data
Press ENTER from Console Port Data Length menu. To change data bits, use the arrow keys to cycle
through to a desired selection and press ENTER.
CONSOLE>BAUD DATA STOP PARITY XONOFF
*8-Bits 7-Bits
4.5.4.3 STOP
Press ENTER from Console Port Stop Bit menu. To change stop bits, use the arrow keys to cycle through to
a desired selection and press ENTER.
CONSOLE>BAUD DATA STOP PARITY XONOFF
*1-Bit 2-Bits
To Next Page
Loading...