Loop Telecom Loop-V 4200 - Parity; Xonoff; Store; Retrieve

Chapter 4 Front Panel Operation
4-14
4.5.4.4 PARITY
Press ENTER from Console Port Parity menu. To change data parity, use the arrow keys to cycle through to
a desired selection and press ENTER.
NOTE: Any changes to this setting will affect a terminal connected to the Console port.
CONSOLE>BAUD DATA STOP PARITY XONOFF
*NONE EVEN ODD
4.5.4.5 XONOFF
Press ENTER from Console Port Xon-Xoff. To change, use the arrow keys to cycle through to a desired
selection and press ENTER.
NOTE: Xon-Xoff flow control will be terminated when SNMP mode is selected
CONSOLE>BAUD DATA STOP PARITY XONOFF
*OFF ON
4.5.5 Store
These menus are used to configure the console port for data rate, data bits, stop bits, parity bit, XON-XOFF
control, interface type, and SNMP control.
MISC>LOCK ERROR_CODE RESET CONSOLE STORE
STORE>STORE RETRIEVE
4.5.5.1 Store
Under the STORE menu, move the cursor to STORE, then press ENTER. The LCD will show as below.
STORE>STORE RETRIEVE
STORING
4.5.5.2 Retrieve
Under the STORE menu, move the cursor to RETRIEVE, then press ENTER. The LCD will show as below.
STORE>STORE RETRIEVE
RETRIEVING