Chapter 5 Terminal Operation
5-6
Example 2:
As the following screen shows, when IP interface is HDLC_PORT, the system will request to enter loopback
time (in second) option. Move the cursor to the “Loopback Timer” option, then key in the desired time.
NOTE:
If you are not planning to do any loopback testing while in the Inband Management(HDLC) mode
leave the timer at its default setting of “0” seconds For more information please refer to section
3.19 Inband Management, in this manual
LOOP V4200-9 === System Setup (SYSTEM) === 15:50:25 03/01/2002
ARROW KEYS: CURSOR MOVE, Please Input: hh:mm:ss mm/dd/yyyy, BACKSPACE to edit
[System]
Time/Date :15:50:07 10/25/2001
IP Interface :HDLC_PORT Loopback Timer (s) : 00018427
IP Address :140.133.001.137 Subnet:255.255.000.000 Gateway:000.000.000.000
Trap IP Address:255.255.255.255
Community Name :public
Device Name :LOOP V4200-9
System Location:8F,No. 8,Hsin Ann Rd.
Science-Based Industrial Park
Hsinchu,30077 Taiwan
System Contact :Name: FAE Tel:+886-3-5787696 Fax:+886-3-5787695
E-mail:FAE@loop.com.tw
Baud Rate : 9600 TSI_FUNC: 1:1(Bidirection)
Data Length : 8-Bits
Stop Bit : 1-Bit
Parity : NONE
XON_XOFF : XOFF
<< Press ESC key to return to previous menu >>
When “CLOCK” is selected, the following screen appears. There are nine choices for Master_Clk Source
and Second_Clk: PORT_A to PORT_F, PORT_H, PORT_J, and PORT_K. Two choice for Master_Clk
Source and Second_Clk Source, and INTERNAL, are available.
LOOP V4200-9 === System Setup (CLOCK) === 09:25:55 07/19/2000
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
Master_Clk Source : PORT_C
Second_Clk Source : INTERNAL
Current Clock : MASTER_CLK
Clk_Recover_mode : AUTOMATIC
Clock Status : NORMAL
<< Press ESC key to return to previous menu >>
5.4 Password Setup
Press “P” to change and enable the password setup.
LOOP V4200-9 === Password Setup === 09:25:55 07/19/2000
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
Enable Password : NO
Change Password : NO
<< Press ESC key to return to previous menu >>
To Next Page
Loading...