Chapter 4 Front Panel Operation
4-5
Press ENTER from Console Port Trap IP menu
IP>INTERF MY-IP SUBNET GATEWAY TRAP-IP
Trap IP Address= 255.255.255.255
The Trap IP Address menu shows the current destination IP address the Loop-V 4200 uses to send an
SNMP trap. The default Trap IP address is a broadcast address (255.255.255.255). To change the Trap IP
address, use the arrow keys to cycle through to the position, and press ENTER to cycle through the numbers.
This operation must be concluded by moving the cursor to OK position and pressing ENTER to enable the
changes.
NOTE: My IP and Trap IP menu only available when the SNMP feature is purchased.
4.2.2 DATE
The Date menu is used to set a new Real Time Clock (RTC) date. From the Configuration menu, use the
cursor to select the Date menu. Press ENTER from Configuration Date menu
To change the date, use the arrow keys to move to the digital position, and press ENTER to cycle through
the numbers. This operation must be concluded by moving the cursor to OK position and pressing ENTER to
enable the changes.
CONTROLLER>IP DATE INFO TSI-MAP MCLK
11:41:40 10/06/1998
DATE>11:42:20 10/06/1998 YES
0123456789
4.2.3 INFO
This Information item displays the software version. It is a read only message.
CONTORLLER>IP DATE INFO TSI-MAP MCLK
INFO>S/W H/W SERIAL
INFO>S/W H/W SERIAL
Version: V0.07 10/01/1998
To Next Page
Loading...