Active Deterrence13
2. Click EVENTS. Click the Event Settings tab on the side panel, then in the drop-down menu
click on Motion. Click on the Smd/Deterrence on the top panel.
3. Select the channel of a connected deterrence camera.
4. Check Enable.
NOTE
This is for automatic warning light triggering only. You can manually activate the warning light and siren
without enabling automatic warning light triggering.
5. Click Set next to Area to set an active area for automatic deterrence.
• The camera image appears with a grid overlay. The green area is the active area for
deterrence.
• Click or click-and-drag to add / remove boxes from the active area.
• In the example image above, only motion around the garage or on the porch will trigger
the warning light.
• Right-click when finished.
#LX400113; r. 9.0/57191/57191; en-US 42
To Next Page
Loading...
Need help?
General