Using the Main Menu16
2. Click , then click SYSTEM. Click the DISPLAY tab on the side panel, then click
the Sequence tab on the top panel.
3. Choose how many channels will appear on screen when Sequence mode is triggered by mo-
tion detection (you must check Sequence when configuring motion detection — see 12 Mo-
tion Detection, page 42 for details).
4. Enter the amount of time in seconds that each channel or page will appear on screen during
Sequence mode.
5. Select a viewing mode to configure. It is recommended to start with View 1 and make your
way to View 9. By default, all viewing modes are included in the Sequence mode cycle.
6. Configure the order of channels shown on screen for each viewing mode. Uncheck channels /
channel groups that you want to remove from the Sequence mode cycle.
7. Click Apply.
16.4.23 Saving Your System Configuration to a USB Thumb Drive
The system allows you to save your current system configuration to a USB thumb drive (not in-
cluded). This is useful if you want to backup your current settings.
NOTE
This function only saves settings created in system menus. It does not save or backup any video.
To save your system configuration to a USB thumb drive:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
#LX400113; r. 3.0/56326/56332; en-US 101
To Next Page
Loading...
Need help?
General