Using the Main Menu16
2. Configure the following:
• SMTP Server: Enter the SMTP server address.
• Port: Enter the port used by the SMTP server.
• Anonymous: Check if your server supports anonymous log ins. Otherwise, leave this
unchecked.
• User: Enter the SMTP user name.
• Password: Enter the SMTP password.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender’s email address.
• ALERT: Enter the subject line for the email alert.
• Attachment: Check to include an image attachment of the camera.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive attach-
ments. For details, see 12 Motion Detection, page 42.
• Encryption Type: Select SSL or TLS if your server uses encryption. Select None if your
server does not use encryption.
• Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be sent pe-
riodically to ensure that the system is functioning normally. Enter the interval in minutes
for health check emails.
3. Click Test to send a test email.
4. Click Apply to save settings.
16.4.5 FTP (Advanced)
Send recordings and/or snapshots to an FTP server.
To configure FTP settings:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click
, then click NETWORK. Click the FTP tab on the side panel.
#LX400113; r. 3.0/56326/56332; en-US 80
To Next Page
Loading...
