LS Industrial Systems SV-iE5 Series User Manual

Chapter 5. Loader
5-5
 Code jump
Moving from code 1(P 0) to the code15(P15) in PG Group
FUNC
SHFT
X5
FUNC
1
-. It displ
ays P0, the 1st code of
Drive Group.
-. Press FUNC key.
2
-. SET lamp lights up. Changeable
number blinks
-
. It shows moving to Code 1 is
possible. Set 5 using UP()
key.
3
-. The 1st digit is changed to 5.
-. Press SHFT key.
-. Blinking cursor moves and 05 is
displayed.
Change it to 1 using
UP() key.
4
-
. It shows moving to Code 15 is
possible.
-. Pressing FUNC key enters 15.
5
-. SET lamp is out.
-. It displays Code 15 of PG Group.
 Code change in PG Group
Moving from code 1 to code 15 in PG group
1
-. It displays Code 1 of PG Group.
-. Keep pressing UP() key until P
15 is displayed.
2 -. It displays Code 15 of PG Group.
Note
Some codes will be skipped in the middle of increment ()/decrement (
) for
code change in PG Group. That is because it is programmed that some codes
are intentionally reserved for later
use or the codes user does not use are
invisible.

LS Industrial Systems SV-iE5 Series Specifications

General

Brand	LS Industrial Systems
Model	SV-iE5 Series
Category	Inverter
Language	English