LS Industrial Systems SV-iE5 Series - Page 60

DECLARATION OF CONFORMITY
ii
TECHNICAL STANDARDS APPLIED
The standards applied in order to comply with the essential requirements of the
Directives 2006/95/CEE "Electrical material intended to be used with certain limits
of voltage" and 2004/108/CEE "Electromagnetic Compatibility" are the following
ones:
• EN 50178 (1997)
“Electronic equipment for use in power installations”.
•EN 61800-3/ (2004)
“Adjustable speed electrical power drive systems.
Part 3: EMC product standard including specific
methods”
• EN 55011/A2 (2003)
“Industrial, scientific and medical (ISM) radio-
frequency equipment.
Radio disturbances
characteristics. Limits and methods of measurement”
•EN61000-4-2/A2 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing
and measurement techniques.
Section 2:
Electrostatic discharge immunity test.
•EN61000-4-3/A2 (2004)
“Electromagnetic compatibility (EMC). Part 4: Testing
and measurement techniques.
Section 3: Radiated,
radiofrequency, electromagnetic field immunity test.
•EN61000-4-4/A2 (2002)
“Electromagnetic compatibility (EMC). Part 4: Testing
and measurement techniques.
Section 4: Electrical
fast transients / burst immunity test.
•EN61000-4-5/A1 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing
and measurement techniques.
Section 5: Surge
immunity test.
•EN61000-4-6/A1 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing
and measurement techniques. Section 6: Immunity to
conducted disturbances, induced by radio-frequency
fields.
•CEI/TR 61000-2-1 (1990)
“Electromagnetic compatibility (EMC). Part 2:
Environment. Environment description for low-
frequency conducted disturbances and signalling in
public low voltages supply systems”
• EN 61000-2-2 (2003)
“Electromagnetic compatibility (EMC). Part 2:
Environment. Compatibility level for low-frequency
conducted disturbance
s and signalling in public low
voltages supply systems”