LSIS H100-2 - Free Run Stop

131
Learning Basic Features
• Note that the motor can overheat or be damaged if excessive amount of DC braking is
applied to the motor or DC braking time is set too long.
• DC braking is configured based on the motor‘s rated current. To prevent overheating or
damaging motors, do not set the current value higher than the inverter‘s rated current.
4.17.3 Free Run Stop
When the Operation command is off, the inverter output turns off, and the load stops due to
residual inertia.
Grou
p
Cod
e
Name
LCD Display
Parameter Setting
Setting Range
Unit
ADV
08
Stop Method
Stop mode
2
Free-Run
0–4
-