Lucent Technologies Lineage 2000 ECS-12U - Page 37

Lucent Technologies Lineage
®
2000 ECS-12U Controller J85501E-2
3 - 2 Ordering Issue 3 July 1998
Same as List C, except with voice response feature.
D
Optional Datalogger circuit pack (CP3) for data
acquisition features.
E
Same as List E, except with a remote termination
panel.
F
Optional Rectifier Adapter Board (RAB) to
interface up to six non-Lineage
®
rectifiers (Lucent
Technologies or non-Lucent Technologies). Note:
A maximum of two RABs can be installed with
each controller.
G
Optional 248A Order Wire Board and mounting
hardware when the controller will be monitored
over the FT-Series G embedded maintenance
system.
H
Optional AKC1B shunt isolator circuit pack and
mounting hardware for a battery plant with the
plant load shunt in the “hot” (ungrounded) lead or
with a plant load shunt not compatible with the
basic ECS-12U controller.
Replaces AKC1 (List J)
P
Same as List A (CP2), with X.25/TL1 features.
K
Same as List B (CP2), with X.25/TL1 features.
L
Same as List C (CP2), with X.25/TL1 features.
M
Same as List D (CP2), with X.25/TL1 features.
N
Kit to add voice response feature to List A, C, K
or M CP2 circuit pack.
KA
Kit to add X.25/TL1 feature to List A, B, C or D
CP2 circuit pack.
KB
Optional mounting hardware for mounting
controller in a 23 inch framework.
BA
Table 3-A: ECS-12U Controller Ordering Information
Description List