Lucent Technologies Lineage
®
2000 ECS-12U Controller J85501E-2
Issue 3 July 1998 Installation and Setup 4 - 1
4 Installation and Setup
Introduction
This section covers the installation and setup procedures for all
configurations of the ECS-12U controller. Follow all the
applicable steps in the following sections in the order they are
presented.
NOTE If the ECS-12U is installed in a UL listed bay, the UL
certification on the bay may no longer be valid.
Tools Required
The tools required in this section are the following.
• Flat-blade screwdriver (for shipped-loose
mounting only)
• Cutter (for wire and for plastic wire ties)
• Jeweler's screwdriver (for alarm wiring)
• Wire strippers (22-26 gauge)
Shipped-Loose
Unit
Installation
Controllers are typically factory wired and assembled to a
battery plant. For custom-engineered applications or as a
replacement, however, the ECS-12U controller may be shipped
as a loose unit. The user must mount and wire a shipped-loose
unit to the plant.
If the ECS-12U controller is received factory assembled as part
of a Lineage
®
2000 battery plant, skip to “Hardware Setup.”
Preparation
On delivery, immediately inspect the shipping carton for
damage. If the crate is damaged, unpack and inspect for damage
to the controller. If the controller was damaged in transit, contact
the carrier for instructions for filing a damage claim. If the unit
To Next Page
Loading...
Need help?
General