LulzBot TAZ Workhorse - Page 48

Cura LulzBot Edition
Infill Before Walls
This option will force your printer to build the inll section of the layer
before printing the inner and outer walls. This is helpful for increasing
adhesion and strength to the outer shells, but can lead to cosmetic defects
on the outer shell.
Infill Support
Inll support will help save material by only printing inll where the tops
of objects require it. While saving time and material, the nal object will
be weaker and not uniformly strong.
Skin Removal Width
Skin removal width will limit how wide your inner and outer walls are on
angled objects and top/bottom layers. This can help reduce material costs,
but can lead to weaker objects and cosmetic defects depending on model
geometry. This can be set for all portions of the model, or just top and/or
bottom layers.
Skin Expand Distance
The skin expand distance setting will force your inner and outer walls into
the inll, increasing adhesion and strength. You can specify this for the
entire object, or just for the top and/or bottom layers.
Maximum Skin Angle for Expansion
Dening the angle and width for skin expansion can rene where and when
the extra material is being laid down. A 90 degree will refer to a vertical
setting, while 0 degrees will represent a horizontal surface. You can also
dene where this happens based upon minimum wall thickness.
48