LulzBot TAZ Workhorse - Page 47

2.10. INFILL TAB SETTINGS
Infill Line Multiplier
This option will multiple how many inll lines are generated internally. By
default your inll will generate one line, multiplying this by 2 will make it
2 lines, side by side, in the same pattern. This can increase part strength
at the cost of additional material and print time.
Infill and Skin Overlap Percentage
Inll and skin overlap percentage dene the amount of overlap with inll
based upon nozzle diameter. Inll overlap will dene the amount of inll
that is extruded into your inner wall, while skin overlap will determine
how much inll is extruded into the outer wall. Setting these too high will
show inll patterns through your outer wall. You can dene each section
by nozzle percentage overlap, or by a specic distance.
Infill Wipe Distance
This setting will determine how far into your inll your nozzle will move
and the end of an inll layer. This will deposit any material on the interior
of the model, and prevent drippage on the outside of your model.
Infill Layer Thickness
You can specify how thick your inll layer lines are here. It is important to
always keep this a multiple of your layer thickness. If this is not a multiple
of layer height, your nozzle can drag through already printed parts.
Gradual Infill Steps and Step Height
These settings modify how inll is generated from base of your object
towards the top of your object. The inll steps will determine how many
times your inll density is halved when moving down from the top of your
object. The step height will determine how “thick” each section is before
being halved.
47