LulzBot TAZ Workhorse - Page 46

Cura LulzBot Edition
• Zig Zag will create an grid inll pattern similar to lines. However
instead of traveling along the interior wall, it will extrude during this
move increasing strength on your nal object.
• Cross will generate a vertical “X” pattern within your inll. This
pattern has a lot of stops and turns, and will increase your print time
of your nal object.
• Cross 3D will generate a 3 dimensional “X” pattern within your
object. As with cross ll, the starts and stops will increase total
print time of your object. The 3 dimensional crosses will also provide
more strength than the standard cross pattern.
• Gyroid generates a wave pattern that rotates rotates along your inner
walls as your object builds up. This generates 3 dimensional shapes
for increased strength, while being very pleasing aesthetically.
Connect Infill Lines
This setting will add extra extrusions along the interior walls of your object.
This helps increase strength of your object, and helps prevent inll lines
from being seen through the outer shell of your objects.
Infill Line Directions
This setting will allow you to dene the direction of inll lines globally. You
will be required to leave the brackets surrounding your input for proper
functionality. It is recommended to check layer view after updating this to
ensure desired results.
Infill Offset Directions
This setting will allow you to change how your oset is placed in either the
X or Y directions. This can be helpful if you have a small part, and would
like to ensure inll is centered in that section.
46