LulzBot TAZ Workhorse - Page 97

INDEX
horizontal expansion, 42
hot end, 77, 80, 86
I
ICES, x
ignore small z gaps, 43
inll, 18, 44
inll before walls, 48
inll density, 44
inll extruder, 44
inll layer thickness, 47
inll line directions, 46
inll line multiplier, 47
inll line width, 37
inll oset, 46
inll overlap percentage, 47
inll patterns, 45
inll speed, 54
inll support, 48
inll travel optimization, 69
inll wipe distance, 47
initial layer height, 37
initial layer line width, 37
initial layer speed, 54
initial printing temperature, 50
inner wall extruder, 39
inner wall line width, 37
inner wall speed, 54
installation, 16
intermittent extrusion, 76
IPA, 80
IRC, 88
ironing, 43
Isopropyl Alcohol, 76
isopropyl alcohol, 80
J
jerk control, 55
K
keep disconnected faces, 66
keep heating, 51
L
latex, 86
lay at, 22
layer height, 17, 36
layer start, 56
layer view, 27
LCD, 33
leveling, 78
lift head, 58
line width, 37
load model, 19
lubricant, 76
M
macOS, 12
maintenance, 76
make overhang printable, 70
manual control, 30
Marlin, 86
material selection, 17
material settings tab, 49
MatterControl, 14
maximum resolution, 70
maximum retraction count, 53
maximum skin angle for expan-
sion, 48
maximum travel resolution, 70
maximum z speed, 54
MAXTEMP, 82
merged meshes overlap, 66
mesh xes, 65
minimal mold width, 67
minimum diameter, 63
minimum layer speed, 58
97