ND30-09D 57 User's manual
4127 RW 0 .. 2
Field separator: 0 - comma , 1 - semicolon ;
2 - tab ' '
,
4128 RW 0,1 Decimal separator 0 - dot '.' 1 - comma ',' .
4129 RW reserved
4130 RW reserved
4131 RW 0…65535
The third and the second byte (B3.B2) of the IP
address of the meter, the IPv4 address format:
B3.B2.B1.B0
49320
(0xC0A8
=
192.168)
4132 RW 0…65535
The first and zero byte (B1.B0) of the IP address
of the meter, the IPv4 address format:
B3.B2.B1.B0
356
(0x0164
= 1.100)
4133 RW 0…65535
The third and the second byte (B3.B2) of the
subnet mask of the meter, the mask format:
B3.B2.B1.B0
65535
4134 RW 0…65535
The first and zero byte (B1.B0) of the subnet
mask of the meter, the mask format:
B3.B2.B1.B0
65280
4135 RW 0…65535
The third and the second byte (B3.B2) of the
default gateway of the meter, the gateway
address format: B3.B2.B1.B0
49320
4136 RW 0…65535
The first and zero byte (B1.B0) of the default
gateway of the meter, the gateway address
format: B3.B2.B1.B0
257
4137 RW 0…65535
The third and the second byte (B3.B2) of the DNS
address of the meter, the IPv4 address format:
B3.B2.B1.B0
0x0808
=8.8
4138 RW 0…65535
The first and zero byte (B1.B0) of the DNS
address of the meter, the IPv4 address format:
B3.B2.B1.B0
0x0808
=8.8
4139 RW Reserved
4140 RW 0,1
Enabling / disabling the DHCP Client (supports
automatic obtaining of IP protocol parameters of
the meter's Ethernet interface from external
DHCP servers in the same LAN)
0 - DHCP disabled - you should manually
configure the IP address and subnet mask of the
meter;
1 - DHCP enabled, the meter will automatically
receive the IP address, subnet mask, and
gateway address from the DHCP server when
switching the supply on or selecting APPL option
from the menu or entering the value "1" to the
register 4099. The gateway address is the
address of the server that assigned the
parameters to the meter;
1
4141 RW 0 .. 2
Baud rate of the Ethernet interface:
0 – automatic selection of the baud rate
1 – 10 Mb/s
2 – 100 Mb/s
0
To Next Page
Loading...
Need help?
General
