User Guide
10
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
3 INSTALLATION PREPARATION
3.1 System and Environmental Requirements
Network cables to connect the XMS-1008P to Ethernet enabled devices
A computer supporting TCP/IP and equipped with a Web browser. Supported
Web browser versions include Microsoft IE 7.0 and up, Safari 1.0 and up or Mozilla
Firefox 1.0 and up. The Web browser is used to confi gure the XMS-1008P.
Power must be AC 100V ~ 220V, 50Hz ~ 60Hz.
Temperature of the operating environment should be: 32F~113F (0C~45C). Place
the switch away from heat generating devices. For best performance and heat
dissipation/ventilation, make sure there is adequate space around the switch.
Humidity of the operating environment should be: 5%-95% non-condensing. Do
not place the switch in an extremely dirty or damp location.
Keep the switch away from strong electromagnetic fi elds (i.e. Air Conditioner
compressors, fl uorescent light ballasts, CRT monitors/televisions, etc.), and free
from vibration, dust and direct sun light.
3.2 Before Connecting to the Network
The XMS-1008P can be rack-mounted or used as a desktop switch. Before con-
necting to the network, please be aware of the following requirements:
Install the XMS-1008P in a stable/safe place to avoid any possible damage
Make sure there is adequate space around the XMS-1008P for adequate ventila-
tion and proper heat dissipation. It is recommended to have at least 4-6 inches
around all sides.
Do not place heavy articles on the XMS-1008P.
Power outlets should be within 5 feet of the XMS-1008P.
Verify the ground connection of the outlet is functioning properly.
Check the power cord to confi rm a secure connection.
Avoid placement in direct sunlight.
When installing the XMS-1008P on a fl at surface, attach the rubber feet to the
bottom of the device to avoid scratching the surface.
4 XMS-1008P INSTALLATION
4. 1 Installation on Desktop/Shelf
As shown below, attach the four rubber footpads to 4 corner indentations on the
bottom of the XMS-1008P. Place the switch horizontally on a solid, level platform.
To Next Page
Loading...
Need help?
General
